Part List for BLINKENmini

*************
* Mechanics * 
*************

30m wood slats 30x10mm
2 wood boards 730x490mm 4mm thick
1 window pane (clear plastic) 730x490mm 2mm dick
2m wood slats (for strenghtening the back board)
1 little piece of wood (to build the plugs for the SNES pads)
glue
screws
nails

*********************
* Connection Cables *
*********************

1 extension cord DSUB 25 pin (max. 5m)
1 extension cord DSUB 9 pin (max. 5m)

****************
* Power Supply *
****************

1 Power Supply 5V 13A (AEH80US05, XP Power GmbH)

***********
* Circuit *
***********

1 circuit board min. 200x160mm
0.5m ribbon cable 18 pin (connection to parallel port plug)
20m thin wire (heat proof is recommended, because of possible contact with soldering iron)
??m solder
25 pin DSUB plug (male) (to parallel port)
1 fuse 1 A
2 fuse 6.3 A
8 high power schottky diodes min. 2A
1 schottky diode
1 electrolytic capacitor 200uF

*****************************
* Circuit - Clock Generator *
*****************************

1 inverter (CMOS 4069)
1 capacitor 100nF (voltage stabilization for inverter)
1 capacitor 47nF
1 resistor 1KOhm
2 resistor 2.2 KOhm
1 resistor 100 KOhm
1 potentiometer 4.7KOhm
1 transistor NPN (e.g. BCY59)

********************
* Circuit - Output *
********************

24 shift register (CMOS 4094)
24 capacitor 100nF (voltage stabilization for shift register)
18 darlington transistor array (ULN2803)
20m ribbon cable 8 pin
144 resistor 39Ohm
144 LED 2.2V 50mA (e.g. Hewlett Packard HPWA-ML00)
(other combinations of resistor and LED are also possible)

*******************
* Circuit - Input *
*******************

4 resistor 10KOhm
9 pin DSUB plug (female)
9 pin DSUB plug (male)
28 silver nails (to built the plugs for the SNES pads)
4 SNES pads